about DucPond

Used Bikes

2000 Ducati 748 RS: $15,000

This is a factory built RS not a street bike. This is a Race Bike. Duc Pond Installed 853 Big Bore Kit.(Magnesium Upper and Lower Triple Clamp, Sand Cast Cases) Other Add On's Are Magnesium Wheels, 2 PC Billet Brembo Brakes, GP Masters Clutch & Brake, Full Floating Discs, Electronic Shifter, Caron Fiber Body, Mid Height DP Race Screen, Carbon Air Runners, Ducati Performance Rear Sets, Remote Brake adjuster, Ohlins Rear Shock, Ohlins Steering Damper, Updated Front Fork Internals, 54mm Termi Exhaust, Technosel Seat. Spares Also Included Extra Wheels, Wheel Stand Fuel Pump, Air Runners, Side Panels, Pegs, Bar Ends, GP Master Levers, Clutch Packs, Eproms, and Service Manual.

 

1997 Ducati 916/955 SP: $12,000
Custom Naked 916

Dymag Wheels, Ohlins Rear Shock, Front Forks are Re valved with Race Tech Valves and re sprung with non progressive springs, EBC Front rotors, Carbon Air Runners, Carbon Front fender, Carbon Rear Hugger,& Termi Exhaust System. 7830 Miles

 

1997 916/955: $13000
916/955

21995 miles. The engine is now a 955 motor. Donnie at Duc Pond Motosports did a 955cc motor kit and head work. It has about 200 miles on the bike since the work was done. This has not even been fully broken in. A Nichols fly wheel was also installed. The owner has full documentation.

Other items...

  • DP chip
  • ITG air filter
  • Forza Carbon Slip-ons
  • ProCutting Hard Anodized or Red Anodized Billet Aluminum Clutch Basket/Barnett Kevlar Clutch Pack Combo Paulimoto Billet Pressure Plate
    Spyder Retainer and Stainless Steel Springs + Vee Two Billet Clutch Hub
  • Blue Silicon coolant hoses
  • Evo clutch slave
  • STM crank case breather CHASSIS:Stock Frame Powder coated red, Stock swing arm
  • Ohlins steering Damper, rear shock and forks with radial mount conversion
  • Converted from Bi Posto to Mono using an aluminum sub frame
  • Moto Wheels rear sets
  • Suspension set up by Donnie at Duc Pond MotoSports
  • Powder coated head light bucket, Frame Inspection cover, Rear brake hanger and caliper, water pump housing, sub frame, rear sprocket carrier and upper triple clamp (All in black). The Frame was done in red.
  • Carbon fiber air box, air runners, hugger, key area cover, V fairing, under tail, sprocket cover, front fender heal guards and dash cover.
  • Brembo 4 pad radial calipers, Brake-Tec Cast iron full floating rotors, rear braking wave rear rotor, GP Billet radial brake and clutch master cylinders, Spiegler black Kevlar brake and clutch lines.
  • Cox Radiator guard
  • Black Marchesini 10 spoke Aluminum wheels
  • WSB spec wind screen
  • Mad Duc break and clutch fluid covers
  • Black renthal grips
  • Afam front and rear sprockets with a DID erv2 520 chain
  • Mini LED front and rear turn signals

The stock rear swing arm stand was powder coated red to match the frame. The body work is still in like new condition. Every after market part on this bike was bought new and does not have more that 1000 miles on it. I have over $25k into this bike.
2007 Ducati Superbike Concorso

 

 

page 1 page 2 • page 3 • page 4

 

 

 

   
         
         
         
         
         
         
         
         
         
           
 

DucPond Motosports: (540) 667-3498 • 663 N. Loudoun St. Winchester, VA 22601

©2007 DucPond Motosports • Site designed by Rocketfuel Design Inc.